favorite
favorite
hide
unhide
flag

Posted

print

Weight Distributing Hitch Receiver - $100 (Erie)

Weight Distributing Hitch Receiver 1 thumbnailWeight Distributing Hitch Receiver 2 thumbnailWeight Distributing Hitch Receiver 3 thumbnailWeight Distributing Hitch Receiver 4 thumbnailWeight Distributing Hitch Receiver 5 thumbnailWeight Distributing Hitch Receiver 6 thumbnailWeight Distributing Hitch Receiver 7 thumbnailWeight Distributing Hitch Receiver 8 thumbnailWeight Distributing Hitch Receiver 9 thumbnailWeight Distributing Hitch Receiver 10 thumbnailWeight Distributing Hitch Receiver 11 thumbnailWeight Distributing Hitch Receiver 12 thumbnailWeight Distributing Hitch Receiver 13 thumbnailWeight Distributing Hitch Receiver 14 thumbnailWeight Distributing Hitch Receiver 15 thumbnail
Hitch Receiver Draw bar

In good condition

2"
2 5/16" ball currently on it
sway bar ball 1 1/4"
Solid shank not square tube

I do not know the weight rating but there are some numbers in the forging, see photo.

Hitch ONLY, NO sway bar, NO weight distribution bars

If you do not need the sway bar ball part I can plasma cut it off AFTER you pay and you can clean it up with grinder.

See photo for approximate dimensions. Hopefully the photo and the text below will give you the info you need.

Approximate Dimensions:
Distance behind ball to rear 10 3/4"
center of front pin hole to rear 5 5/16"
center of rear pin hole to rear 3 1/4"
overall height from mounting surface 5 1/2" add 3 1/2" for ball height
from receiver bottom to bottom 3 1/4"
from rear of welded on part to rear 8"

AS-IS

Map does not show exact location only a general point for reference.

post id: 7751781442

posted:

best of [?]

loading
reading
writing
saving
searching